A CLEARER PICTURE OF YOUR SETUP

Check the inputs your controller reports.

Check controller buttons, axes and triggers in your browser. Run a guided check, observe stick position and save a local report. No account required.

✓Free to use✓No sign-up✓On your device

Meet your controller.

A little movement tells you a lot.
Waiting for controller
⌁
No controller detected yet
Connect by USB or Bluetooth, then press a button
ABXY
Input detectedAt rest
Generic standard layout

Every key has a say.

Click here, then press letters or numbers. Tested keys stay highlighted. Your keystrokes stay in this tab.

Make every click count.

Click inside the test area. This preview counts left, middle and right button presses; it does not measure hardware latency.

Left 0 · Middle 0 · Right 0Click here to test

A clean look at your screen.

Cycle through solid colors to inspect your display visually. Click to change color; press Escape to exit. This is not a calibration tool.

1
Buttons & triggers

Press each button and slowly squeeze both triggers.

Show numbered raw inputs
No controller detected.
No installs. No account. Just your browser.
Made for standard gamepad inputs. Available readings depend on your controller, browser and connection.No input data is uploaded.

How to use this check

Connect and identify

Connect one controller to your computer by USB or pair it through the operating system. Open this page and press a face button. The page reads the first controller exposed by the browser. If several devices are connected, disconnect the others to avoid inspecting the wrong one.

Check each input

Press the buttons, squeeze both triggers and move the sticks. The diagram is a generic standard layout, not a picture of your particular device. With a non-standard mapping, use the numbered raw inputs below rather than assuming that A, B, LT or RT labels match your hardware.

Keep a useful record

The report captures browser readings at the moment you save it. A resting-stick measurement, if completed, is included separately. Demo mode is optional and its readings and reports are clearly marked as simulated. No result is a certification that a controller is fault-free.

Readings reflect what your browser exposes. Compatibility and mapping must be checked on each device. Read our measurement method and limitations.